MD ARM INSTALLATION INSTRUCTIONS - rev 04/22/14 pjm
Page 3 of 3
MD ARM INSTALLATION INSTRUCTIONS
ATTACH FLIP UP
1. Remove screws from
drop extension using
5/32” hex key.
2. Align holes in keyboard
tray with screw holes in
drop extension.
3. Attach keyboard tray
using the provided
screws.
IF USING PARALINK KEYBOARD TRAY
IF USING ULTRA
KEYBOARD TRAY
ADJUST MD ARM RESISTANCE
Using the 3/16”
t - h a n d l e h e x
wrench provided,
turn the screw in the
MD arm clockwise
to lighten the arm’s
load resistance, or
counter-clockwise
to increase the load
resistance.
ATTACH COVERS TO MD ARM
After lowering the arm to the
down position, slide on the
lower cover. Using a Phillips
head
screwdriver
(NOT
POWER TOOLS), reattach the
four screws attaching the lower
cover.
Attach the top cover by
reattaching the four top cover
screws using a Phillips head
screwdriver (NOT POWER
TOOLS).
WARNING - PINCH POINT:
Keep fi ngers away from the
inner arm area where the gas
spring is located.
OR
ATTACH QUICK DISCONNECT
1. Remove beauty cap on quick
disconnect block.
2. Remove screw using 3/16”
hex key.
3. Slide keyboard tray into quick
disconnect block.
4. Replace screw and tighten.
5. Replace beauty cap.
Beauty cap
Screw
ATTACH PARALINK KEYBOARD TO MONITOR
Attach the Paralink
Keyboard Mount to the
Monitor Mount by using
the 3/8-16 screw and lock
washer provided.
