Security Settings
Input Settings
The Input settings define the input configuration that will trigger a security alert.
⦁
Input Detect
: Select to enable input detection.
⦁
Key
: Select the DSS key or call which will trigger the alert.
⦁
Trigger Mode
:
-
When set to
Low Level
the input will trigger when the connection is opened or disconnected.
-
When set to
High Level
the input will trigger when the connection is closed or connected.
⦁
Detection Duration
: The duration (in seconds) that the input must be activated before the alert will be
triggered.
If no duration is set the alert will not be triggered.
⦁
Alert message send to server
: When selected the intercom will send a
SIP
alert message to the server.
⦁
Reset Alert message send to server
: When selected the intercom will send reset messages to the server.
Output Settings
⦁
Output Response
: Select to enable the onboard output.
⦁
Output Level
:
-
When set to
High Level
output levels operate as specified in
Connection Terminals
.
-
When set to
Low Level
all contact output levels are inverted.
⦁
Output Duration
: The time (in seconds) that the output remains activated when a trigger occurs.
Alert Trigger Settings
Output
The Output settings allow you to configure the alert triggers that will activate the onboard output.
⦁
Input Trigger
: Whenever the input configuration meets the trigger condition the output will be triggered.
-
Reset Mode
: The triggered output can be reset when the
Input
state changes or the
Duration
expires.
⦁
Remote DTMF Trigger
: Enables triggering the output by Dual Tone Multi Frequency.
-
Trigger Code
: The DTMF code entered into a phone keypad to activate the output.
-
Reset Code
: The DTMF code to reset the output.
-
Reset Mode
: The triggered output can be reset when then DTMF
State
changes or the
Duration
expires.
⦁
Active URI Trigger
: Enables triggering by Uniform Resource Identifier. The output is activated/deactivated
when an http get is called for
http://{intercom ip}/cgi-bin/ConfigManApp.com?egs&output{output
number}={Trigger Message or Reset Message}
.
-
Trigger Message
: The message to activate the output.
-
Reset Message
: The message to reset the output.
⦁
Remote SMS Trigger
: Enables triggering by SMS message.
-
Trigger Message
: The SMS message to activate the output.
-
Reset Message
: The SMS message to reset the output.
⦁
Call State Trigger
: The output will be triggered when the call state of the intercom matches the selected state.
The following options can be selected by moving the required state(s) to the
Enabled State
list.
-
Talking
-
Ringing
-
Calling
-
Calling and Talking
PRT-IPIC-POE-C | Vandal Resistant VoIP Intercom with Camera | Installation Manual
38