Hardware Configuration
Power on Sequence
The intercom takes approximately 25 seconds to boot after power has been supplied.
Once booted, open a web browser and enter the intercom's IP (
default is 192.168.1.128
) in the address bar.
Log in when prompted:
User
: admin,
Password
: admin
Finding the Intercom on the Network
Select the IP Address # Key
If the currently configured IP address is unknown:
1.
Ensure the intercom is powered on.
2.
Remove the screws using the hex key provided and remove the
front panel
.
3.
Lift the
main body
of the intercom out of the enclosure.
4.
Locate and press the
#
labeled button on the
circuit board
for 3 seconds to activate an audio message
through the built-in speaker which will announce the intercom's IP address.
5.
Connect to the web interface by entering the IP address into the address bar of your web browser.
6.
Log in when prompted:
User
: admin,
Password
: admin
PRT-IPIC-POE-C | Vandal Resistant VoIP Intercom with Camera | Installation Manual
21