6
Innovative Circuit Technology Ltd.
The inverter may be mounted horizontally on a shelf, or the ICT rack tray, or in a
vertical wall mounted orientation. Install the unit with either side located on top
(as shown in Figure 3) when wall mounting to ensure proper cooling and long
term safe operation of the inverter. (Mounting hardware not included)
Figure 3: Approved Mounting Orientations
Connect the chassis ground stud on the back panel to a reliable earth ground
point.
Ensure the inverter switch is in the off position, then connect the dc input wiring
from a suitable deep-cycle lead-acid battery to the inverter using appropriately
rated wire size (see DC Wire Sizing Guide), and an in line over current protection
device/disconnect switch or breaker (with disconnect switch in “off” position).
Terminate wire with appropriate size of ring tongue to fit the 5/16” input bus bar
mounting bolts.
