Innovative Circuit Technology Ltd.
5
3 pin Form-C alarm connector plug
Wall mounting bracket, with mounting screws (4), installed
Instruction Manual
Bus bar connection 5/16 inch bolt, nut, and washer set (2)
Mount the optional wiring junction box base (part of the Wiring Junction Box kit
ICT-DCWB) to the back of the inverter with 4 supplied screws, as shown in Figure
1. Knockout the plugs and install conduit fittings or wire strain relief clamps in
the wiring box openings to be used for the installation, as required. The inverter
must be installed in a restricted access environment such as an enclosed
equipment rack if the back panel wiring junction box is not used.
Figure 1: Wiring Junction Box Installation
Mount the inverter using the wall mount bracket (included) or the optional 19
inch rack-mount tray (ICT-RMK4) using the 4 mounting screws on the bottom of
the inverter, as illustrated in Figure 2. Keep the distance to the battery bank as
short as practical to minimize power loss in the high current wiring. (see DC Wire
Sizing Guide table)
Figure 2: Inverter Wall Bracket Mounting
