Innovative Circuit Technology Ltd.
25
b.
Enter the HTTP port number that the PDU is using in the
Start
and
End
fields. The default HTTP port for the PDU is
80
.
c.
Select
Both
under
Protocol
(TCP and UDP)
d.
Enter the local IP address of the PDU (e.g. 192.168.0.180) in the
IP
address
field. (see step 2 of the
TCP/IP Web Based Utility
section to
verify the PDU IP address)
e.
Check the
Enable
box, and then click on
Save Settings
NOTE:
Many ISP’s block
access to port 80, so if your ISP does block this port you must
change the HTTP port the PDU uses from 80 to something else, such as 8000.
(Valid port numbers are in the range of 1 to 65535) See the
Network Setup
section for information on assigning new network ports.
You must also change the PDU
’s HTTP port from 80 if your local network has
another device (such as a PDU, or web server) already using port 80.
3.
Configure HTTPS forwarding by repeating steps 2a to 2e with the HTTPS
port number that the PDU is using. The default HTTPS port number is
443
.
Figure 6: Router Port Forwarding Screen
4.
Determine the WAN IP address of your router assigned by the ISP. With
the example router this information is on the
Status
tab, listed as
IP
Address
.
NOTE:
