DALI MODE
DALI 2AMDI511VPVRDBS WIRING - FIGURE N. 5
In order to activate this mode of control/operation it is necessary to shortcircuit the D+ and D- inputs and connect
the DALI bus between the DALI/P1 and DALI/P2 inputs.
On the first reception of a properly formatted DALI package the dimmer is configured in DALI mode. Once
configured in DALI mode and disconnected from the DALI bus the dimmer switches to the POWER ON LEVEL
mode set through DALI bus.
The maximum current absorbed by the DALI bus is about 2mA.
ATTENTION IN THIS MODE THE BLE (Bluetooth) CONTROL IS FORBIDDEN
Below you can find the implemented standard commands:
DIRECT ARC POWER
OFF
UP
DOWN
STEP UP
STEP DOWN
RECALL MAX LEVEL
RECALL MIN LEVEL
STEP DOWN AND OFF
ON AND STEP UP
GO TO SCENE (0-15)
RESET
STORE ACTUAL LEVEL IN THE DTR
STORE THE DTR AS MAX LEVEL
STORE THE DTR AS MIN LEVEL
STORE THE DTR AS SYSTEM FAILURE LEVEL
STORE THE DTR AS POWER ON LEVEL
STORE THE DTR AS FADE TIME
STORE THE DTR AS FADE RATE
STORE THE DTR AS SCENE (0-15)
REMOVE FROM SCENE (0-15)
ADD TO GROUP (0-15)
REMOVE FROM GROUP (0-15)
STORE DTR AS SHORT ADDRESS
QUERY STATUS
QUERY BALLAST
QUERY LAMP POWER ON
QUERY LIMIT ERROR
QUERY RESET STATE
QUERY MISSING SHORT ADDRESS
QUERY VERSION NUMBER
QUERY DEVICE TYPE
9
IOTLIGHT - User Manual 2AMDI511VPVRDBS
