© 2022 ICS, Oregon Tool Inc.
F/N 51873
Feb 22
TITLE
ICS
®
RZ60C OPERATOR’S MANUAL
6
WARNING
A potentially hazardous situation exists which, if not avoided,
could result in death or serious injury.
The items listed below are critical to minimizing the risk of injury
or equipment damage.
• DO NOT operate this machine unless you have read and understand this operator’s manual.
• DO NOT operate the saw with damaged, modified, broken, or missing guards.
• DO NOT allow blade exposure from the guard to be more than 180 degrees.
• Read all safety materials and instructions that accompany any blade used with this saw.
• Use only abrasive blades or high-speed diamond blades marked for use with gasoline-powered,
hand-held, portable, abrasive cutting-off machines.
• DO NOT use abrasive blades that are less than 1/8” (3.17 mm) thick.
• DO NOT use abrasive blades that are not reinforced.
• DO NOT use abrasive blades or diamond blades that are not specifically rated for at least 5100
rpm on 14” (350 mm) or 6200 rpm on 12” (300 mm). Excessive speed could result in blade
breakage.
• DO NOT use damaged blades. Always inspect the blade thoroughly.
• DO NOT use an abrasive blade that has been dropped.
• DO NOT use carbide-tipped or toothed type blades of any kind.
• DO NOT grind on the side of a blade.
• DO NOT cock, jam or wedge the blade in the cut.
• Inspect the saw flanges and shafts for damage before installing the blade. DO NOT use if
damaged or worn.
• Verify the blade arbor hole matches the machine spindle before mounting the blade.
• Mount the blade solidly and firmly. Wrench tighten the arbor screw.
• Make sure the blade and flanges are clean and free of dirt and debris before mounting the blade
on the saw.
• DO NOT insert the blade into a slot narrower than the blade. Rapid pushback may occur.
• DO NOT run the saw upside-down. Debris can fly back into the operator’s face.
• Always turn the saw OFF before performing maintenance on the saw.
• DO NOT use equipment that is not functioning properly.
• Turn engine OFF before refueling and allow the engine to cool.
• Keep fuel away from open flame.
• Always provide adequate ventilation when handling fuel.
• Make sure the gas cap on the saw and the fuel can are properly tightened.
• Move the saw at least 10 feet (3 m) away from refueling area before starting.
SAFETY
Содержание RZ60C
Страница 1: ...2022 ICS Oregon Tool Inc RZ60C OPERATOR S MANUAL...
Страница 2: ......
Страница 30: ......
Страница 31: ......