ICS Nav6plus, Руководство пользователя

Страница: 65 / 90

NAV6 plus NAVTEX System User Guide
65
TESTING THE NAV6 AFTER INSTALLATION
TESTING THE NAV6 AFTER INSTALLATION TESTING THE NAV6 AFTER INSTALLATION
TESTING THE NAV6 AFTER INSTALLATION
•
Carefully check all connections
before applying power
• Switch on the power supply by
closing the 1.5A circuit breaker or
power panel switch
• Check that the red LED illuminates
for approximately 8 seconds and
then goes out and the start-up page
appears on the NAV6 display. The
start-up progress bar at the bottom
of the page will disappear when the
system is ready to use. Press any
key to show the next screen
Sensor
Check that both the ‘490’ and the ‘518’ icon appear on the status line at
the top of the NAVTEX display.
If the correct icons do not appear, refer to the Maintenance and Trouble
Shooting section.
NMEA input
When the display is receiving GPS data the ‘GPS’ icon will appear on
the status line at the top of the NAVTEX display. If the icon does not
appear, ensure that the NMEA source is operating and check the NMEA
data connections; you may have to swap the NMEA DATA A and DATA
B wires.