ICS Nav6plus, Руководство пользователя

Страница: 57 / 90

NAV6 plus NAVTEX System User Guide
57
required to mount the display on a bulkhead, tabletop or to hang it
from a deckhead
The best viewing angle is square on to the display.
Select a suitable mounting location, one that is that is flat, free from
excessive heat and vibration and which is convenient for routing the 1m
long connecting cable.
•
When panel mounting consider rear cable access
•
Avoid direct sunlight. If mounting the display unit in an exposed
location protect it when not in use by using the suncover option -
ICS part number 6020.03
•
Position the Display at least 0.5metres away from other electronic
equipment including GPS antennas, VHF radios, Radar etc.
•
Observe recommended ‘Compass safe’ distance of 1m
The display unit cable connects directly to the ‘screw terminal block’ (or
inside an expanded system NAV6
hub ). Mount the terminal block close
to the display (1m max.) in a convenient, accessible but dry location.
Mounting the Display Unit Mounting the Display Unit Mounting the Display Unit Mounting the Display Unit
You will need: 102mm (4") hole saw
3mm drill for fixing screws.
Cross head screwdriver.
Drilling template, (remove from centre pages)
Method:
•
Prepare the flat mounting surface, check behind for the necessary
clearance, a minimum of 50mm is required.
•
Use the drilling template to mark out the centres for the 102mm hole
and the two 3mm holes.
•
Double check all is clear behind the panel and drill the holes.
•
Remove the two screw covers from the Display Unit.
•
Apply a releasing agent (grease or petroleum jelly) to the rubber
seal around the back of the NAV6. This will prevent the seal from
sticking to the bulkhead surface over time.