© 2021 ICS®, Oregon Tool Inc. REV12232021 P/N 610794
536-E OPERATOR MANUAL
15
DO NOT operate the power cutter with damaged, modified, broken, or missing
components.
•
The tool contains safety features, designed to protect against electric shock,
contact with moving parts, ejected debris, broken chain, thrown water, and
concrete slurry.
•
Parts with damage or excessive wear should not be used or repaired, they should
be replaced.
Use only Genuine ICS replacement parts. Use of aftermarket parts may result in
injury or damage to the power cutter.
WARNING
DO NOT insert the guidebar into a slot narrower than the width of the chain.
Rapid pushback, kickback and/or chain breakage could result.
DO NOT operate the power cutter without an adequate water supply.
The integral water supply channels in the guidebar act to cool and lubricate the cutting
system as well as to suppress dust and debris generated during cutting. Assure that
the water supply is capable of delivering 20 psi (1.4 bar ) pressure to the power cutter at
a minimum flow rate of 2 gpm (8 lpm).
Never attempt to cut ductile iron pipe or similar pipe materials with the
power cutter unless using PowerGrit® Utility Chain.
Using concrete cutting chain in these applications can cause the chain to snag abruptly
in the cut which may result in chain breakage, pushback and/or kickback.
Safety
