© 2021 ICS®, Oregon Tool Inc. REV12232021 P/N 610794
536-E OPERATOR MANUAL
29
CUTTING WITH THE POWER CUTTER
DO NOT insert the guidebar into a slot narrower than the width of the chain.
Rapid pushback, kickback and/or chain breakage could result.
Be sure cut concrete cannot fall and injure the operator or bystanders.
Assure cut piece is controlled and does not fall unexpectedly.
NOTE: Concrete is very heavy;
30 cm x 30 cm x 30 cm = 68 kg (12 in x 12 in x 12 in = 150 lbs).
Slippery or unstable surfaces such as ladders may cause a loss of balance or
control of the power cutter.
Always keep proper footing and operate the power cutter only when standing on fixed,
secure and level surface.
Unexpected loss of control of the power cutter and loss of balance can result in
injury.
Do not overreach and do not cut above shoulder height.
Do not allow workpiece to pinch the guidebar and chain, kickback or rapid
pushback could result.
Always cut bottom of opening first and assure workpiece is secure and does not shift
during cutting operations. Support the workpiece such that the cut remains open
throughout the cutting operation, including when the cut is finished.
Do not operate power cutter upside down.
Cutting debris can be directed back towards the operator.
Take special precautions when cutting in horizontal orientation.
Be aware that debris may be ejected differently than when cutting in a vertical position.
WARNING
CAUTION
Operation
