ICRealtime THIP-P2078FM-IR, Быстрый старт

Страница: 20 / 29

Installation 9
4
Installation

Make sure the mounting surface is strong enough to hold at least eight times of the camera
weight.

The following figure is for reference only, and the actual product shall prevail.
Cable Preparation
Selecting Needed Video Cable

75 ohm.

Full cable with copper conductor.

95% knitted copper shield.
Table 4-1
Video cable
International Model Max Transmission Distance (Ft/M)
RG59/U 750Ft/229M
RG6/U 1,000Ft/305M
RG11/U 1,500Ft/457M
Selecting Needed Power Cable
It is recommended to install the matched power within 5m from the device if it is allowed; but if
not, then it needs to extend the power supply cable, but it has to guarantee the voltage of the
device input port (thermal hybrid dome output cable) is no lower than 12V
± 20% DC.
Selecting Needed Signal Cable
All signal cables (audio, alarm input and output and RS-485 etc.) are recommended to use
0.56mm (24AWG) and above cable as lengthened wire signal cable.
Installing Camera
4.2.1
(Optional) Installing SD Card

Please cut off the device power before installing SD card.

Be cautious and do not mistake Micro SD card slot for reset hole. Long press the reset
button for 4 seconds–5 seconds and you will reset your Camera.