MAINTENANCE MANUAL
SAVANNAH S
Doc. No.:
MM-SVNH-EN
Revision:
07
Rev. Date:
07/11/2022
Proj. Ref.:
SVNH S
A/C:
Savannah S
Applies to Generic Serial Number:
yy-mm-54-xxxx
Page:
46/132
DOC
FMM00
Structure /
System
N°
Inspection item
Action / Description
Main landing
gear tail
dragger (if
configured
with)
12b.
01
Brace rods
(add to the previous list)
Verify main landing gear spring brace
rods integrity, no cracks on welding at
the ends, uniball closed
Nose landing
gear
13.01
Support structure
Verify integrity of landing gear leg, lower
structural box, leg spar and upper
landing gear support on the firewall
13.02
Fork
Verify fork is straight
13.03
Axle
Verify ring nut with teeth washer closed
and bolts on axle closed with safety wires
13.04
Free play
Check the free play of the landing gear
leg lower sliding plates, not major than 2
[mm] (if necessary replace)
13.05
Lubrication
Lubricate with white grease the nose
landing gear sliding and rotating points
13.06
Shock absorber
Verify bungee enough strong against
compression, it must stay totally
extended (at empty weight) after return
from a 5 [cm] manual compression
13.07
End of run
Verify integrity of end of run absorber
(red vulcolan ring)
13.08
Steering rods
Verify uniball of push-pull rods of steering
are closed, both for nose leg and cabin
sides. Verify no rubbing in firewall holes
for the entire travel
13.09
Wheel
Verify wheel rim perfectly round
13.10
Tyre
Verify tyre consumption (replace if
necessary). Verify pressure from 1.5 to
2.5 [bar], as required by the wheel type
13.11
Fairing
Verify nose wheel fairing rigidly
supported and not damaged
Table 19h