ICP ICP9014RO, Инструкция по установке и эксплуатации

Страница: 34 / 142

3-3
Installing the Driver
4 Click Create Driver Disk , then select the appropriate operating
system.
5 If you selected Linux , you must also select the architecture:
– i386 —For Intel 386 or 486 computers
– i586 —For Pentium I or II computers
– i686 —For Pentium III, IV, or AMD K-6 computers
– Athlon —AMD Athlon computers
6 Select the appropriate floppy disk drive letter, then choose the
appropriate format. A full format is required only if the disk has
never been formatted or if it contains bad sectors.
7 Insert a floppy disk, then click OK . The system creates the
driver disk.
8 Remove and label the driver disk.
Now that you have created your driver disk, proceed with the
appropriate driver installation procedure.
Installing the Windows Driver
This section contains the following procedures:
■
Installing the Driver When You Install Windows
■
Installing the Driver in an Existing Windows System
Installing the Driver When You Install Windows
To install the driver while also installing the Windows operating
system, follow these steps:
1 Install and configure the controller and hard disk drives, as
described on
page 2-2 .
2 Create the bootable array, as described on page 2-4 .
3 Create the driver disk, as described on page 3-2 . When finished,
remove the driver disk.
4 Insert the Windows setup CD and restart the computer to begin
the Windows installation.