3-4
Installing the Driver
5
When prompted to install a third-party driver, press
F6
.
Note:
When F6 is active, a prompt appears at the bottom of
the screen for only 5 seconds. If you miss your chance to
press F6, restart the computer.
6
Insert the driver disk and wait until prompted to install the
driver. Press
S
to specify that the driver is on the floppy disk,
then press
Enter
. The computer reads the disk.
7
When the driver is found, press
Enter
. Respond to the on-screen
instructions to complete the installation.
Installing the Driver in an Existing Windows System
To install the driver in an existing Windows system:
1
Install and configure the controller and hard disk drives, as
described in
2
Create the driver disk, as described on
remove the driver disk.
3
Start Windows. Windows launches the Found New Hardware
Wizard, which searches for the driver.
4
Insert the driver disk, select the floppy drive as the source, then
click
Next
.
5
Click
Next
in the two subsequent windows and follow the
on-screen instructions to complete the driver installation.
6
Remove the driver disk and restart the computer.
