ICP Electronics ROCKY-3732EVS, Руководство пользователя

Страница: 43 / 64

43
Onboard FDC Controller
Select Enabled if your system has a floppy disk controller (FDC)
installed on the system board and you wish to use it. If you install and-
in FDC or the system has no floppy drive, select Disabled in this field.
The choice: Enabled, Disabled.
Onboard Serial Port 1/Port 2
Select an address and corresponding interrupt for the first and second
serial ports.
The choice: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled,
Auto.
UART 2 Mode
This item allows you to select which mode for the Onboard Serial Port 2.
The choice: Standard, HPSIR, ASKIR.
IR Function Duplex
This item allows you to select the IR half/full duplex funcion.
The choice: Half, Full.
TX ,RX inverting enable
This item allow you to enable the TX, RX inverting which depends on different
H/W requirement. This field is not recommended to change its default setting
for avoiding any error in your system
The choice:
No, No/ No,Yes(Default)/ Yes, No/ Yes, Yes.
Onboard Parallel Port
This item allows you to determine onboard parallel port controller I/O address
setting.
The choice: 378/IRQ7, 278/IRQ5, 3BC/IRQ7, Disabled,
Parallel Port Mode
Select an operating mode for the onboard parallel (printer) port. Select
Normal, Compatible, or SPP unless you are certain your hardware and
software both support one of the other available modes.
The choice: Normal, EPP, ECP,ECP/EPP
ECP Mode Use DMA
Select a DMA channel for the parallel port for use during ECP mode.
The choice: 3, 1.