Installation Guide
Chassis
Make sure the copper lifting stands are placed below all the mounting holes of your backplane.
SBC
Apply only one full-sized SBC over PICMG slot or half-sized SBC over ISA slot.
Apply your ISA/PCI cards over ISA/PCI slot (Image 1).
Power Supply
1.If you use AT power supply, attach the P8/P9 connector to PW1 (Image. 2).
2.If you use ATX power supply, attach the 20-pin ATX power connector to PW2 (Image. 3).
Besides, you need to apply one 3-pin ATX power control cable between your SBC and backplane
over the 3-pin header CN2. (A toggle switch is required over your SBC for this application.
Image. 4).
3.If you use ATX power supply, you may also plug a switch into pin-2 and pin-3 of CN2. In this
application, the 3-pin ATX power control cable is not required, and your ATX power supply will
then act as AT power supply (Image. 5).
5
PX-8S-RS User’s Manual
Image 1
Image 2
Image 4
Image 3
