![background image](http://html.mh-extra.com/html/icp-electronics/lcd-kit01/lcd-kit01_user-manual_614714010.webp)
LCD-Kit01 640 x 480 / 18 bits
P64CV1
17
4.2 BIOS Setting for SBCs with HM86508 Chipset
Note
: to upgrade the BIOS, under DOS prompt insert the
attached disk then type the bold letter command of the middle
column then follow the instruction on your monitor.
Example: for NOVA-300 SBC, under DOS prompt type:
A:\
flash634 n300lcd1.rom
or
C:\
flash634 n300lcd1.rom
if you have copied the files
flash634.com
and
n300lcd1.rom
to your hard-disk.
BIOS Setup
LCD Volt. Setting
JUKI-730
use
flash634 j730lcd1.rom
to upgrade bios
No volt. Setting
(ALi6117)
(5V only)
JUKI-732E
use
flash634 j732lcd1.rom
to upgrade bios
No volt. Setting
(ALi6117)
(5V only)
JUKI-750E
use
flash631 j750lcd1.rom
to upgrade bios
No volt. Setting
(ACC Maple)
(5V only)
JUKI-752
use
flash631 j752lcd1.rom
to upgrade bios
No volt. Setting
(ACC Maple)
(5V only)
PM-1021
use
flash634 1021lcd1.rom
to upgrade bios
No volt. Setting
(ALi6117)
(5V only)
NOVA-300
use
flash634 n300lcd1.rom
to upgrade bios
No volt. Setting
(ALi6117)
(5V only)
WAFER-4823
use
flash631 4823lcd1.rom
to upgrade bios
No volt. Setting
(ACC Maple)
(5V only)
LCD-Kit01
LCD-Kit01 640 x 480 / 18 bits
P64CV1
18
Appendix A.
P64CV1 Display – Switch Setting
There are two switches on the back of LCD01 Display. These
switches have been set to the factory-setting. Your LCD01 comes
in ready-to-use condition, don’t change this setting unnecessary.
Notes: 1. HP6~HP0 is for picture level setting
2. U/D is for picture horizontal rotation
3. R/L is for picture vertical rotation
4. Don’t change the ‘system internal setting’