LCD-Kit01 640 x 480 / 18 bits
P64CV1
15
4
Voltage and BIOS Setting
After all jumpers and connectors have been set and connected
correctly, the next step is to set the Voltage and BIOS of the LCD-
Kit01. These settings are done on your SBC.
Voltage Setting
The Supply Voltage for LCD-Kit01 is +5V. You must set the
LCD
Voltage Setting
Jumper on your SBC to +5V. Please, refer to SBC
User Manual of your SBC or refer to the following tables.
BIOS Setting
For SBCs with C&T 65555 LCD/CRT Interface Chipset, the setting
can be done simply in CMOS Setup. For SBCs with HM86508
LCD/CRT Interface Chipset, the BIOS setting must be done by
upgrading the VGA BIOS using the BIOS file in the attached disk.
Please, refer to the following tables for more detail information.
Note:
To do the above settings, you must have one VGA monitor
connected to your SBC because your LCD-Kit01 may not work
correctly or even does not show anything before the Voltage and
BIOS settings are correct.
LCD-Kit01 640 x 480 / 18 bits
P64CV1
16
4.1 BIOS Setting for SBCs with C&T 65555 Chipset
BIOS Setup
LCD Volt. Setting
JUKI-710
Standard CMOS Setup:
JP9: 2-3 > ON
LCD&CRT: Auto or Both
5-6 > ON
Panel & P.M.U. Setup:
Panel Type:
6 :640x480 18Bit TFT Color
JUKI-740E
Peripheral Setup:
JP39: 2-3 > ON
LCD&CRT Selection : Auto or Both
LCD Type :
#6 640x480 18bit
JUKI-745E
Peripheral Setup:
JP39: 2-3 > ON
LCD CRT Selection: Auto or Both
LCD Type :
#6 640x480 18bit
NOVA-600
Peripheral Setup:
JP10: 2-3 > ON
LCD CRT Selection: Auto or Both
LCD Type :
#6 640x480 18bit
POS-566
Peripheral Setup:
JP23: 2-3 > ON
LCD CRT Selection: Auto or Both
LCD Type :
#6 640x480 18bit
LCD-Kit01
