ICP DAS USA PET-7060, Руководство пользователя

Страница: 19 / 156

Chapter 1 Introduction
PET-7000 DIO User Manual, May 2009, V1.00, EMH-013-10----------
19
Table 1-2 LED Indicators
Name LED Action Function
Run
Flashing Firmware is running
ON Ethernet link detected
OFF No Ethernet link detected
LINK/ACT
Flashing Green Ethernet packet received
OFF Speed 10 Mbps 10/100M
Orange Speed 100 Mbps
J1 Connector
Refer to Sec.1.3 Module Selection for more details regarding the pin assignment of the
J1 Connector for all types of PET-7000 series modules.
J2 Connector
Table 1-3 J2 Connector
Pin number Name Function
8 +VS The PET-7000 series can be powered using an
auxiliary power +12 VDC ~ +48 VDC
(non-regulated)
9 GND Ground connection
The definition of pin8 and pin9 applies to all types of the PET-7000 series modules. The
definition of the other pins is dependent on the type of the PET-7000 series module.
Note:
If the Run LED does not display the information as above, the following steps
should be taken:
z
Power-off the module
z
Check that the Init/Normal switch is in the Normal position.
(Refer to Back Panel Description)
z Re
-
power-on the module and double check the LED indicators.