i'coo Targo, Инструкция по эксплуатации

Страница: 18 / 48

10
gB
Care and MaIntenanCe
generaL PoIntS
Please check the proper functioning of the push-chair
regularly. ensure that the frame is stable, that the screws
and bolts are secure, that latches and catches are properly
locked, that the wheels are fixed and that the brakes are in
good working order. From time to time, check the strength
of the textile cover seams and that plastic parts are in good
condition. It is essential that defective or worn parts are
replaced immediately. the same applies to components which
are broken, torn, defective or worn. Please replace these only
with original i’coo spare parts.
do not expose the push-chair to excessive sunshine as this
can cause the textiles covers and plastic parts to fade.
CLeanIng the CoVerS
remove the cover from the frame by undoing the straps,
knobs or screws. Before washing the cover, please read the
washing instructions given on the sewn-in label.
Clean the cover by solely wiping it down evenly with a damp
cloth. If textile covers have inserts which cannot be removed,
ensure that this process does not soak the part through
completely. Providing there are no plastic, wooden or metal
parts attached to or inside the cover, it can be washed in a
washing machine at 30° and spin-dried at medium speed.
allow the cover dry in the open air, although not in intense
sunshine.
In order to prevent shrinkage, please do not dry the cover in
a heat-tumble drier
do not re-install covers until they are completely dry.
CLeanIng the FraMe
only use a mild soap lye or lukewarm water to clean the frame of the
push-chair.
dry the push-chair with a soft cloth after cleaning or exposure to rain
or snow.
Plastic parts can be cleaned with normal household cleaning agents.
CLeanIng the WheeLS
Clean and service the wheels regularly. treating them with a silicon
spray or an anti-corrosion spray protects against rust and deposits.
In Winter, ensure that grit and salt from the pavement is wiped away
immediately. Clean dirt away from the wheels and axes on a regular
basis.
CIty-FraMe
the separate parts (1a)
• City-frame
• 2 front wheels
• 2 rear wheels
unFoLd/FoLd
unlock the transportation lock on the left side of the stroller (2).
unfold the pushchair by pulling up the handlebar until the
locking mechanism on both sides audibly and visibly clicks
into place (3a).
FoLdIng the PuShChaIr
Press the secondary lock on the right-hand side of the upper
handlebar (3c). With the button held in, pull both handlebar
locks upward. now the frame lock is released and you can
fold the pushchair down.
handLeBar
adjust the handlebar by pushing the buttons on both sides
simultaneously (4a) and rotate to the desired height.