24
HOW TO ADJUST THE DRIVE BELT
If the pedals slip while you are pedaling, even when
the resistance is adjusted to the highest level, the drive
belt may need to be adjusted.
To adjust the drive belt, you must remove the right
pedal, the right access disc, and the right shield as
described below.
Using an adjust-
able wrench, turn
the Right Pedal (26)
counterclockwise
and remove it. Then,
using a standard
screwdriver, release
the tabs around the
edge of the right
Access Disc (10),
and then remove it
from the Right Shield (18).
See assembly step 5 on page 9.
Remove the
two M4 x 16mm Screws (8) from the Rear Shield
Cover (9). Next, use a standard screwdriver to release
the tabs along the bottom edges of the Rear and
Front Shield Covers (9, 19). Then, remove the two
M4 x 12mm Screws (61), and remove the Rear and
Front Shield Covers.
See the EXPLODED DRAWING on page 27.
Identify the Left and Right Shields (17, 18). Remove
all of the screws from the Left and Right Shields;
there
are two sizes of screws in the shields—note which
size of screw you remove from each hole.
Then,
gently remove the Right Shield.
Next, loosen the M6 x 20mm Hex Screw (60). Then,
tighten the M10 x 50mm Hex Screw (33) until the Drive
Belt (23) is tight. When the Drive Belt is tight, tighten
the M6 x 20mm Hex Screw.
Then, reattach the parts that you removed.
26
18
10
23
60
33
Содержание PRO-FORM CYCLE TRAINER 400 Ri
Страница 4: ...4 STANDARD SERVICE PLANS...
