7
2. Identify the Right Upright (74) and the Left
Upright (73). Hold the Right Upright near the
Right Base Cover (77).
See the inset drawing.
Locate the wire tie in the rectangular hole in the
lower end of the Right Upright. Tie the wire tie
securely around the end of the Upright Wire
Harness (75). Then, pull the other end of the wire
tie up through the Right Upright until the Upright
Wire Harness is routed through the Right
Upright.
Gently pull up on the Upright Wire Harness (75)
as you set the Right Upright (74) on the Base
(83) inside the Right Base Cover (77).
Be care-
ful not to pinch the Upright Wire Harness.
Attach the Right Upright (74) to the Base (83)
with two 3/8" x 3 3/4" Bolts (72) and two 3/8"
Star Washers (90).
Do not tighten the Bolts
yet.
Note: It may be necessary to tip the tops of
the Uprights forward slightly as you thread the
Bolts into the Uprights.
Set the Left Upright (73) on the Base (83) inside
the Left Base Cover (76). Attach the Left Upright
to the Base with two 3/8" x 3 3/4" Bolts and two
3/8" Star Washers (not shown).
Do not tighten
the Bolts yet.
With the help of a second person, lower the
treadmill off the cardboard stand. Save the card-
board stand for step 9.
83
76
75
Wire
Tie
77
2
74
73
90
72
3. Identify the Right Upright Sleeve (96) and the
Left Upright Sleeve (95); the Upright Sleeves
are marked. Slide the Right Upright Sleeve onto
the Right Upright (74), and slide the Left Upright
Sleeve onto the Left Upright (73).
95
“Right”
“Left”
96
3
74
73
75
74
Wire
Tie
