14
HOW TO TURN ON THE POWER
IMPORTANT: If the treadmill has been exposed to
cold temperatures, allow it to warm to room tem-
perature before turning on the power. If you do not
do this, the console displays or other electrical
components may become damaged.
Plug in the power cord (see
page 12). Next, locate the
power switch on the treadmill
frame near the power cord.
Make sure that the switch is
in the reset position.
IMPORTANT: The console features a display demo
mode, designed to be used if the treadmill is dis-
played in a store. If the displays light as soon as
you plug in the power cord and press the power
switch into the reset position, the demo mode is
turned on. To turn off the demo mode, hold down
the Stop button for a few seconds. If the displays
remain lit, see HOW TO PERSONALIZE CONSOLE
SETTINGS at the right to turn off the demo mode.
Next, stand on the foot
rails of the treadmill.
Locate the clip at-
tached to the key, and
slide the clip securely
onto the waistband of
your clothes. Then, in-
sert the key into the
console. After a moment, the displays will light.
IM-
PORTANT: In an emergency, the key can be pulled
from the console, causing the walking belt to slow
to a stop. Test the clip by carefully taking a few
steps backward; if the key is not pulled from the
console, adjust the position of the clip.
IMPORTANT: If there is a sheet of plastic on the
face of the console, remove the plastic. To prevent
damage to the walking platform, wear clean ath-
letic shoes while using the treadmill. The first time
the treadmill is used, observe the alignment of the
walking belt, and center the walking belt if neces-
sary (see page 26).
Note: The console can display speed and distance in
either miles or kilometers. To find which unit of mea-
surement is selected, see HOW TO PERSONALIZE
CONSOLE SETTINGS to the right. For simplicity, all
instructions in this manual refer to miles.
HOW TO PERSONALIZE CONSOLE SETTINGS
The console features a settings mode that allows you
to view the total time and total distance the walking
belt has moved, select a system of measurement for
the console, turn on and turn off the demo mode, se-
lect a personal trainer setting, adjust the volume and
contrast settings of the console, and select an audio
equalizer setting.
Follow the steps below to personalize the console
settings.
To select the settings mode, first remove the key from
the console. Then, hold down the Stop button while
reinserting the key into the console.
When the settings mode is selected, the top of the dis-
play will show the total number of hours that the tread-
mill has been used and the total number of miles or
kilometers that the walking belt has moved.
The display will show the word ENGLISH or METRIC
to indicate which system of measurement is selected.
To change the system of measurement, press the
Speed increase button.
The console features a display demo mode, designed
to be used if the treadmill is displayed in a store. While
the demo mode is turned on, the console will function
normally when you plug in the power cord, press the
power switch into the reset position, and insert the key
into the console. However, when you remove the key,
the displays will remain lit, although the buttons will not
function. Press the Speed decrease button to select
OFF (to turn off the demo mode), PROGRAMS (to dis-
play previews of various workouts), ROAD (to display
an animation of a runner on a road), or VISUAL EQ (to
display a visual equalizer).
Reset
Key
Clip
