3
11
. With a reciprocating saw, cut the UCA droop tab from the coil bucket. Paint all exposed metal.
(FIGURE 9)
12
. Slide the ICON coilover assembly into position and fasten it using the supplied 3/8” bolts and washers with a 9/16” socket/wrench
[Torque to 30ft-lbs]. Make sure the reservoir hose is pointing toward the rear of the truck.
(FIGURE 10)
Place the reservoir mount on
top of the coil bucket before as shown.
(FIGURE 11)
13
. The bottom spacers on the coilover assembly push the coilover away from the CV boot. Installing these spacers backwards will
cause the CV boot to rub the rod end. Reuse the factory lower bolt and a 21mm socket/wrench to fasten. [Torque to factory spec]
(FIGURE 12)
15
.
Mount the reservoir to the reservoir mount using the supplied hose clamps and a 5/16” nut driver
. (FIGURE 13)
14
. Use the supplied 3/8” hardware to fasten the sway bar back to the chassis using a 9/16” socket/wrench. [Torque to 45 ft-lbs]
Failure to install this relocator kit will cause the sway bar ends to make contact with the coil cup.
(FIGURE 14)
FIG.9
FIG.12
FIG.13
FIG.14
FIG.11
FIG.10
