4
15
. Using a 13mm socket/wrench loosen the brake line bracket on the coil bucket. Push it down and slightly bend it rearward.
[Torque to factory spec]
(FIGURE 15 AND 16)
16
. Reattach the UCA to the knuckle using a 18mm socket/wrench. [Torque to factory spec]
(FIGURE 17)
17
. Verify that brake line tab and UCA do not make contact at full droop.
(FIGURE 18)
18
. Reassemble sway bar links using 13mm and 15mm socket/wrench. [Torque to factory spec]
(FIGURE 19)
19
. Reconnect the tie rod to the knuckle using a 21mm socket/wrench. [Torque to factory spec]
(FIGURE 20)
20
. Repeat all installation steps on the passenger side.
21
. Reinstall plastic skidplate using 15mm socket/wrench. [Torque to factory spec]
(FIGURE 21)
22
. Install wheels and lower vehicle to the ground. [Torque to factory spec]
23
. Have the truck professionally aligned.
RETORQUE ALL NUTS, BOLTS AND LUGS AFTER 100 MILES AND PERIODICALLY THEREAFTER.
VERIFY ALL FASTENERS ARE PROPERLY TORQUED BEFORE DRIVING VEHICLE.
FIG.17
FIG.18
FIG.19
FIG.20
FIG.21
FIG.15
FIG.16
