4
16
. Install the driver side coilover: The reservoir hose will point towards the front of the vehicle indicating the driver side. With the
reservoir bracket sandwiched between the coil bucket and the coilover mount, use the supplied 3/8” hardware to fasten the coilover
to the coil bucket. [Torque to 45 ft-lbs] Twist the hose and loop around to the reservoir mount as shown and attach reservoir to
mount using the supplied hose clamps with a 5/16” socket/wrench.
[FIGURE 14]
NOTE: failure to use the supplied reservoir bracket will cause the hose fitting to crash into the coil bucket.
17
. With the supplied 1/2” hardware, mount the lower eyelet of the shock to the axle. Use a jack to help locate the assembly.
[Torque to 80 ft-lbs]
[FIGURE 15]
18.
Reinstall the plastic wheel liner.
[FIGURE 16
]
19.
Repeat steps on passenger side. Reattach the trackbar. [Torque to factory spec]
20
. Install wheels/tires and remove vehicle from jack stands. [Torque lugs to factory spec]
21.
Center the steering wheel by turning the tie rod adjuster.
[FIGURE 17]
22
. Have the vehicle professionally aligned.
RETORQUE ALL NUTS, BOLTS AND LUGS AFTER 100 MILES AND PERIODICALLY THEREAFTER.
VERIFY ALL FASTENERS ARE PROPERLY TORQUED BEFORE DRIVING VEHICLE.
FIG.14
FIG.17
FIG.16
FIG.15
