8
SCAN OPERATION
31
■
Frequency skip function
D
Programming a skip frequency
Unwanted frequencies can be skipped and programmed as
skip channels when full or programmed scan is pausing.
q
Turn ON the frequency skip function as described at right.
w
Start full scan or programmed scan. (p. 29)
e
While receiving an unwanted signal and scan pauses,
push [
(S.MW)
MW] for 2 sec. to program the received fre-
quency as a skip frequency.
• Do not release [
(S.MW)
MW] before 2 sec., otherwise, scan stops
and select memory mode is selected.
• The transceiver emits 3 beeps and the scan resumes.
• Non-programmed memory channels are used for skip frequency
programming from channel 99 to 10 in reverse sequence.
• To scan the skip frequency after programming, cancel the skip
information or clear the memory channel. (pgs. 25, 30)
NOTE: When the frequency skip function is turned OFF,
the paused frequency is overwritten on the preselected
memory channel.
D
Frequency skip function ON/OFF
The frequency skip function can be turned OFF in set mode.
In this case, the frequencies will not be skipped even if skip
information is programmed and “
” will not blink during full
scan or programmed scan.
S
SETTING THE FREQUENCY SKIP FUNCTION ON/OFF
q
Turn power ON while pushing [
(MAIN)
SCAN] to enter
scan set mode.
w
Push [
(H/L)
J
] or [
(TONE)
K
] several times until “SKIP SC”
appears as shown above.
e
Rotate [DIAL] to turn the frequency skip function ON or
OFF.
r
Turn power OFF to exit scan set mode.
USING
Scan set mode
The frequency skip
function is ON.
The frequency skip
function is OFF.
