8
DTMF MEMORY
8-4
You can monitor the programmed DTMF code
sequence.
1. Push [FUNC], and then push [DTMF-M] to enter
the DTMF memory mode.
2. Push [
Y
] or [
Z
] to select the desired DTMF
memory channel.
3. Push [MONI] to monitor the DTMF memory
contents.
• The programmed DTMF code sequence
sounds, and then the transceiver automatically
exits the DTMF memory mode.
Beep
Beep
Beep
Example: Monitoring DTMF memory channel “d3.”
(DTMF memory mode)
Push [MONI].
The DTMF code sequence sounds.
Push
, and then push
.
Push
or
to select DTMF memory channel “d3.”
The transmitting speed of DTMF code can be set to
accommodate your operating needs.
1. Hold down [ ] for 1 second to turn OFF the
transceiver.
2. While holding down [
Y
] and [
Z
], hold down [ ] for
1 second, to turn ON the transceiver to enter the
Initial Set mode.
3. Push [
Y
] or [
Z
] to select the DTMF TX speed
item (dtd).
4. Rotate [VOL] to select the desired transmitting
speed, as shown below.
• “dtd. 1”: 100 milliseconds interval; 5.0 cps rate
• “dtd. 2”: 200 milliseconds interval; 2.5 cps rate
• “dtd. 3”: 300 milliseconds interval; 1.6 cps rate
• “dtd. 5”: 500 milliseconds interval; 1.0 cps rate
(cps=characters per second)
5. Push [# ENT] to exit the Initial Set mode.
The “DTMF TX speed” item in the Initial Set mode
(“3” is selected.)
Monitoring a DTMF memory
Setting DTMF transfer speed