2-4
2.
REPEATER OPERATION
When communicating through a repeater, the transmit
frequency is shifted up or down from the receive
frequency
1 Push [SET LOCK] to enter the Set mode
2 Repeatedly push [SET LOCK] or [MONI ANM PA]
until the “±” and the frequency offset are displayed
3 Rotate [DIAL] to set the desired frequency offset
• Push [V/MHz SCAN] to change the frequency step
between 1 kHz and 1 MHz
4 Push any key other than [SET LOCK] or
[MONI ANM PA] to save the selection and exit the
Set mode
Using the HM-133V
1 Push [SET B D-OFF] to enter the Set mode
2 Repeatedly push [SET B D-OFF] or
[ENT C T-OFF] until the “±” and the frequency
offset are displayed
3
Push [▲] or [▼] to set the desired offset.
• The frequency cannot be directly entered using the
keypad
4 Push [CLR A MW] to save the selection and exit
the Set mode
LOCK
SET
ANM
MONI
DUP
LOW
T-SCAN
TONE
PRIO
M/CALL
SCAN
V/ MHz
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
The Repeater Lockout item
[SET LOCK]
[ ]
Frequency Offset
Repeater Lockout
This function helps prevent interference to other
stations by inhibiting transmitting when a signal is
received
The transceiver has two inhibiting conditions, “RP”
(repeater) and “BU” (busy)
1 Hold down [ ] for 1 second to turn OFF the
transceiver
2 While holding down [SET LOCK], hold down [ ]
for 1 second to enter the Initial Set mode
3 Repeatedly push [SET LOCK] or [MONI ANM PA]
to select “RLO” (Repeater Lockout)
4 Rotate [DIAL] to set the Repeater Lockout function
option to “RP,” “BU,” or “OF”
• “OF”: The Repeater Lockout function is OFF
• “RP”: Transmit is inhibited when a signal with an
unmatched subaudible tone is received
• “BU”: Transmit is inhibited when a signal is received
5 Push [ ] to save and exit the Initial Set mode
LOCK
SET
ANM
MONI
AO
MUTE
NAR
MID
LOW
The Frequency offset item