Icom IC-G80, Инструкция по эксплуатации, Страница: 42 / 48

37
9
SET MODES
D LCD Contrast
Selects the LCD contrast.
• Lcd.LO : Sets the contrast to low.
• Lcd.At : Sets the contrast to high. However, if the transceiver is
exposed to high temperatures, it automatically sets the
contrast to low.
D Power Save
The Power Save function allows you conserve battery life by
selecting the duty cycle of the receiver. Select the ratio of the
power save time to the standby time.
To turn OFF the function, select “P–S.OF.”
• P–S.OF : Turns OFF the function.
• P–S. 2
: Sets the duty cycle to 1:2. (ON: 0.1 sec., OFF: 0.2 sec.)
• P–S. 8 : Sets the duty cycle to 1:8. (ON: 0.1 sec., OFF: 0.8 sec.)
• P–S.16 : Sets the duty cycle to 1:16. (ON: 0.1 sec., OFF: 1.6 sec.)
• P–S.At
: Automatically sets the duty cycle.
When no operation occurs and no signal is received
for 5 seconds, the transceiver enters the Power Save
mode, and sets “1:2” as the duty cycle, and after 60
seconds, it sets “1:16” as the duty cycle.
D Dial Acceleration
Selects whether or not to accelerate the changing speed
when rotating [VOL] rapidly.
• S–S. m : Turns OFF the selecting speed acceleration.
• S–S. At : The selecting speed is automatically accelerated when
rapidly rotating [VOL].
D Microphone Simple mode
Microphone Simple mode is used to assign the essential opera-
tions to the four switches (S1 to S4) on the remote control unit.
• mS .Sm
• mS .n1
• mS .n2
S1 Turns the Monitor function ON or OFF
S2
–
S3 Selects the channel 1
S4 Selects the channel 2
S1 –
S2
–
S3 Channel up
S4 Channel down
S1
Turns the Monitor function ON or OFF
S2 –
S3 Channel up
S4
Channel down