Icom IC-F3GS, Руководство по обслуживанию

Страница: 17 / 83

5 - 7
Minimum distortion
level
12 dB SINAD
At the point where
the audio signals
just appears.
1 • Operating frequency:
136.000 MHz (L-band)
146.000 MHz (H-band)
• Connect a standard signal generator to
the antenna connector and set as:
Frequency : 136.000 MHz (L-band)
: 146.000 MHz (H-band)
Level : 5.6 µV* (–92 dBm)
Modulation : 1 kHz
Deviation : ±3.5 kHz (W-type)*
1
±2.8 kHz (M-type)
±1.75 kHz (N-type)*
1
• Set the NARROW ch. [W/N-type] only
• Receiving
• Operating frequency:
136.000 MHz (L-band)
146.000 MHz (H-band)
• Connect a standard signal generator to
the antenna connector and set as:
Frequency : 136.000 MHz (L-band)
146.000 MHz (H-band)
Level : OFF
Modulation : 1 kHz
Deviation : ±3.5 kHz (W-type)* 1
±2.8 kHz (M-type)
±1.75 kHz (N-type)*
1
• Receiving
• Receiving
RX
SENSITIVITY
[BPF T1] –
[BPF T4]
SQUELCH
LEVEL
[SQL]
Top
panel
Top
panel
Connect a SINAD meter with an
8
Ω
load to the [SP] jack.
Connect a SINAD meter with an
8
Ω
load to the [SP] jack.
ADJUSTMENT ADJUSTMENT CONDITION
MEASUREMENT
VALUE
UNIT LOCATION
*The output level of the standard signal generator (SSG) is indicated as the SSG’s open circuit.
SOFTWARE ADJUSTMENT – continued
Select an operation using [
↑
] / [
↓
] keys, then set specified value using [
←
] / [
→
] keys on the connected computer keyboard.
CONVENIENT:
The BPF T1–BPF T4 can be adjusted automatically.
q
-1: Set the cursol to “BPF ALL” on the adjustment program and then push [ENTER]
key.
q
-2: The connected PC tunes BPF T1–BPF T4 to peak levels.
or
w
-1: Set the cursol to one of BPF T1, T2, T3, or T4 as desired.
w
-2: Push [ENTER] key to start tuning.
w
-3: Repeat
w
-1 and
w
-2 to perform additional BPF tuning.
1
2
*
1
W/N-type must adjust both (W-type) and (N-type).