Icom IC-7700, Инструкция по эксплуатации

Страница: 52 / 232

3-14
3
BASIC OPERATIONS
D Programming the user band edge
q
Select the Others set mode and select the “Beep
(Band Edge)” option.
w
Rotate the main dial to select either the “ON (User)”
or “ON (User) & TX Limit” setting.
• [BAND] appears above
F-5
.
e
Push [BAND]
F-5
to open the band edge screen.
r
Push [
Y
]
F-1
or [
Z
]
F-2
to select the desired
band edge.
• Push [ t u ]
F-3
to select the upper and lower band
edge frequency entry cell.
• Push [INS] (MF6) to insert a new blank band edge line.
• Hold down [DEL] (MF7) for 1 second to delete the se
-
lected band edge line.
t
Push F-INP ENT , and then input the desired fre-
quency with the keypad.
• Push
GENE
•
to input decimal point (“.”) between the
MHz and kHz digits.
• Program each channel from left to right and each fre -
quency must be higher than the preceding frequency.
• The frequency that is duplicated, or out of an amateur
band, cannot be programmed.
• If you want to return the band edge frequencies to
their default (initial) value, hold down [DEF]
F-4
for
1 second.
The band edge initialize screen appears as shown
below, then hold down [OK]
F-6
for 1 second to initial-
ize all band edge frequency settings.
y
Push F-INP ENT to set the input frequency.
u
Push
EXIT/SET
to exit the set mode.
Appears when “ON (User)” or “ON (User) & TX Limit” is
selected.
• Band edge screen