![background image](http://html.mh-extra.com/html/icom/ic-440/ic-440_instruction-manual_612149018.webp)
■
Turning power ON
q
Push and hold
for 2 sec. to turn the power ON.
w
If the transceiver is programmed for a start up password,
input the digit codes as directed by your dealer.
•
The keys in the table below can be used for password input:
•
The transceiver detects numbers in the same block, as identi-
cal. Therefore “01234” and “56789” are the same.
e
When the “PASWD” indication does not clear after input-
ting 4 digits, the input code number may be incorrect. Turn
the power off and start over in this case.
■
Volume selection
➥
Push
or
to select the desired volume level.
•
“
” appears when volume level 0 is selected (while the internal
speaker is muted).
■
Channel selection
➥
Push
CH
SQL
to enter the channel selection mode, then push
or
to select the desired channel.
•
While pushing and holding
or
, the displayed channel
changes continuously until channel 1 is selected.
•
When channel 1 is selected, beeps are emitted.
•
‘CB-XX’ appears when the CB channel is selected and ‘RX-XX’
appears when the RX channel is selected.
•
“
” appears when channel selection mode is selected.
14
3
BASIC OPERATION
KEY
NUMBER
0
5
4
9
3
8
2
7
1
6
MONI
F
SET
T SQL
PRIO
LOW
SCAN
O
G
P
CH
SET
P
RS
TAG
SQL
[PWR]
O
G
P
RS
SCAN
TAG
PRIO
SET
P
LOW
O
G
P
RS
SCAN
TAG
PRIO
SET
P
LOW
Appears
IC-440-1.indd 14
IC-440-1.indd 14
2008/06/25 15:59:33
2008/06/25 15:59:33