2
1
INSTALLATION AND CONNECTIONS
New2001
1
BASIC MANUAL
New2001
3. Slide the MBA-8’s guide down over the MBF-1’s locking
head, as shown below.
L
Be sure the locking head fits into the slot at the top of the
guide.
4. Tighten the lock knob to securely attach the controller.
5. Adjust the viewing angle of the controller, then tighten
the adjustment knob.
Guide
MBA-8
Lock knob
Locking head
(MBF-1)
Adjustment knob
■
Installing the controller
D
When installing into your vehicle
You can install the controller on the dashboard or the
console of your vehicle with the optional MBA-8
controller
bracket
and the MBF-1
mounting
base
.
1. Attach the MBF-1 to the dashboard or the console.
L
See the MBF-1 instruction manual for details.
Magnet*
MBA-8
Longer
M2.6 × 8
screws*
Suction pad
Base lever
MBF-1
2. Attach the MBA-8 to the controller’s rear panel with
the supplied longer screws (M2.6 × 8 mm), as shown
below.
Controller
Controller
NOTE:
There are 2 lengths (6 mm and 8 mm) of screws
supplied with the optional MBA-8 controller bracket.
•
NEVER
use any screws other than the supplied screws
(M2.6 × 8 mm) to attach the controller bracket. Otherwise
the transceiver’s internal board may be damaged.
•
NEVER
use any screws other than the supplied screws
(M2.6 × 6 mm) to attach the magnets. Otherwise the
transceiver’s internal board may be damaged.
*Supplied with the MBA-8.
