ICM Controls SC 5011, Инструкция по установке, эксплуатации и применению

Страница: 21 / 32

Testing the Thermostat
Once the thermostat is configured, it should be thoroughly tested .
CAUTION!
: Do not energize the air conditioning system when the outdoor temperature is
below 50 degrees . It can result in equipment damage or personal injury .
Fan Test
1 . Press FAN (right) button . Fan displays . Indoor fan turns ON .
2 . Press FAN (right) button . Indoor fan turns OFF .
Heat Test
1 . Press SYS (left) button until heat mode is displayed .
2 . Adjust the set temperature so it is 5 degrees above the room temperature .
3 . Heat should come on within a few seconds . Red LED may turn on .
4 . Adjust the set temperature 2 degrees below the room temperature and the
heat should turn off . There may be a fan delay on your system .
Note: For heat pumps, there is a four-minute delay to protect your
compressor after it turns off .
To bypass the compressor time delay, go to OFF mode for 5 seconds .
PM
Cool Test
1 . Press SYS (left) button until cool mode is displayed .
2 . Adjust set temperature so it is 5 degrees below room temperature .
3 . A/C should come on within a few seconds . Green LED may turn ON .
4 . Adjust the set temperature 2 degrees above the room temperature and the
A/C should turn off . There may be a fan delay on your system .
Note: There is a four-minute time delay to protect the compressor after it
turns off .
To bypass the compressor time delay, go to OFF mode for 5 seconds .
PM
PM
OFF