ICM Controls SC 5011, Инструкция по установке, эксплуатации и применению

Страница: 11 / 32

Remote or Outdoor Sensor Installation (Optional)
1 . Remove cover from remote sensor housing .
2 . Select an appropriate location for mounting the remote sensor .
3 . Mount remote sensor unit using hardware provided .
4 . Install two strand shielded wire between remote sensor and thermostat . Shielded wire must be used .
Do not
run remote sensor wire in conduit with other wires .
•
Wire 1
should run between the S1 terminal on the thermostat and the S1 terminal on the remote sensor
• Wire 2 should run between the S2 terminal on the thermostat and the S2 terminal on the remote sensor
• Connect the shielding of the wire to the S2 terminal on the thermostat
5 . Configure the thermostat to operate with the remote sensor (see Configuration Mode setting 10, Page 14) .
Note:
Remote or outdoor sensor reading can be displayed by
simultaneously pressing the Down and SYS buttons .
Remote Sensor: (Shown: Optional ICM ACC-RT103 Remote Indoor Sensor;
for outdoor sensor, order ACC-OD103.)