Operation (Continued)
Changing Fahrenheit to Celsius
The temperature displays in degrees Fahrenheit as a factory set default. Follow these steps to change to
degrees Celsius:
Step 1:
Remove the cover and the batteries.
Step 2:
Move the
F/C
jumper to the desired position,
F
or
C
using the center pin as a common.
Step 3:
Reinstall the batteries and the cover.
Your LCD readout changes accordingly.
Starting the Thermostat
Step 1:
Move the
Fan
switch into the
Auto
position.
• In
Auto
, indoor fan runs only during a heating or cooling cycle
• In
ON
, indoor fan runs continuously
Step 2:
Move the
Mode
switch to either
Cool
or
Heat
position, depending on
the season. The thermostat will now operate and maintain the room
temperature at the desired setpoint.
Note:
When the thermostat operates the system, there is built-in
compressor protection. After the compressor turns off, the
system will not turn it back on for about five minutes. This
protects the compressor.
Cool Off Heat
Mode
Auto
On
Fan
Содержание SC 2300
Страница 15: ...This page left blank intentionally ...
