APEX 200 USER MANUAL
21
8-3 Alarms
8-3-1 Alarm Input
The device supports 1 active alarm input (photoelectric isolation), and the input
voltage range is 3V ~ 5.5V.
8-2 Manual IP Address Configuration
Configure the network to be the same as the thermal camera as follows:
1.
Click Windows icon.
2.
Click Settings.
3.
Click on Network and Internet.
4. Click Ethernet.
5.
Click Change Adapter Settings.
6.
Right click Ethernet and choose properties. For touchscreens, press and
hold until a box pops up; then, release hold.
7.
Double-click on Internet Protocol Version 4 (TCP/IPV4) Properties.
8. The IP address should read 192.168.1.110. If it does not, click in the box and
fill in the correct number.
9.
The Subnet Mask should read 255.255.255.0. If it does not, click in the box
and fill in the correct number.
10. Click OK.
8-3-2 Alarm Output
The device supports 2 alarm outputs (switch value and photoelectric isolation),
3V ~ 25V DC, maximum 85 m.
