APEX 200 USER MANUAL
20
THE THERMAL IMAGER NEEDS SUFFICIENT TIME TO WARM-UP FOR THE MOST
ACCURATE TEMPERATURE MEASUREMENTS AND BEST IMAGE QUALITY.
THIS TIME CAN OFTEN VARY BY ENVIRONMENTAL CONDITIONS. IT IS BEST
TO WAIT A MINIMUM OF 10 MINUTES FOR THE DEVICE TO COMPLETELY
WARM-UP.
8-1 Power On/Off the Device
After installing the thermal camera in the preferred position, use the cable to
connect the thermal camera and the computer as normal. There are two power
supply methods for the APEX 200:
1.
Do one of the following:
•
Connect the device to the PoE port of the power supply through the
M12 8-pin adapter cable, or
•
Connect to the DC power supply through the M12 12-pin adapter
cable.
2.
Connect the APEX 200 to the network.
3.
Power on the device, and wait for 2 minutes. The power indicator light is
steady blue when fully powered. The network indicator light flashes green
when the network connection is normal.
4. Modify the computer network segment to be the same as the thermal
camera (see
Section 8-2 Manual IP Address Configuration
).
Temperature measurement and analysis is most accurate after 30 minutes.
Monitoring is available through the computer software (see Chapter 0-0
Software)
8.
Operation Instructions
AFTER POWERING OFF, WAIT TEN SECONDS BEFORE ATTEMPTING TO
POWER THE DEVICE ON AGAIN.
