ICI AL-FBM71TYN-RT, Инструкция по установке и использованию, Страница: 7 / 8

ICI BUMPER INSTALLATION
STEP 25
Attach the provided rubber
trim to the length of the side
edges of the cover plate. It
may be necessary to use a
small mallet to ensure that
the trim is properly
attached.
STEP 26
Use 8 of the provided M8
bolts and finish washers to
attach the cover plate to the
winch carrier. Center the plate
so it is square on the vehicle
and tighten the mounting
bolts. Also install the fairlead
to the front of the winch cover
plate - longer bolts may be
necessary for this.
Figure 25.
STEP 27
Attach the OE bumper cover
to the side support brackets
using the provided M8 bolt
and finish washer. Adjust the
bumper cover so it minimizes
the gap between the winch
cover plate and the OE
bumper cover, once satisfied
with the fitment, fully tighten
all bolts. Refer to STEP 22.
Figure 2 7 .
12 13
STEP 22
Install the side support
brackets to the winch carrier
with the provided M8
hardware.
NOTE: Do not fully tighten and
do not attach to the bumper
cover as illustrated yet. This is
done to illustrate where the
support attaches.
STEP 24 (LIGHTING)
Install the lighting of your
choosing to the light mount
bracket. Then mount the
bracket to the cover plate
and adjust it until your
lighting is centered on the
front opening.
NOTE: The light bracket
accommodates up to a 30”
LED light bar.
STEP 23
The small slots along the back
edge of the winch carrier are
for wire management, the
winch wires and fog light
harness can be zip tied to
these slots to keep them out
of the way and secure.
Figure 24.
Figure 23.
ICI BUMPER INSTALLATION
Figure 2 2 .
Figure 2 6 .