iCharger 1010B+ Скачать руководство пользователя

Страница: 15 / 32

-15-

iCharger Synchronous Balance Charger/Discharger 3010B

Charging a Lithium battery in normal CHARGE mode

The

iCharger

first charges with constant current (CC) according to the user setting then constant voltage (CV)

when the charging voltage reaches the peak point. In the CV phase the current gradually falls. The

iCharger

will terminate charging when the current falls below than 1/10 of the configured charge current.

Fast charging a Lithium battery

The

iCharger

first charges with constant current (CC) according to the user setting then constant voltage (CV)

when the charging voltage reaches the peak point. In the CV phase the current gradually falls. The

iCharger

will terminate charging when the current falls below than 1/5 of the configured charge current. This will result
in slightly less than 100% charge but will complete sooner than the Normal charge mode.

The left side of the first line set the type of battery (LiPo, Lilo or LiFe). The
value on the left side of second line sets the charge current and the value
on the right side of second line sets the cell count and voltage of the battery
pack. After setting the current and voltage, press

Start/Enter

for more than

3 seconds to start the next process.

Charge current: 0.05

–

30A, Voltage: 1

–

10 series ( LiFe to 12 series)

The number of cells you set and the processor detects. If the checking
result is the same, it would enter to the next interface; if not the same, the
left side of the first line ‘R:xxSER‘ shows the number of cells detected by the

iCharger

and the right side of the first line ‘S:xxSER‘ is the number of cells

set by the user. Usually, the auto-detect number won‘t exceed the number
set by the user. You should make sure that the configured number and the
actual number for the battery are the same and then you can start charging
by pressing

Start/Enter

. If not, press

Batt type/Stop

to go back to the

previous screen and adjust the setting.

Lithium CHARGE mode. The screen shows the status during the charging
process. You can stop charging at any time by pressing

Batt type/Stop

Press

Inc



to display each cell‘s voltage (see the balance voltage

information) and press



Dec

to display the General Status information.

battery

voltage

number

of cells

Series

charged

capacity

charging

time

charge

current

work

State

The fast charging mode of Lithium battery. The left side of the first line set
the type of battery (LiPo, Lilo or LiFe). The value on the left side of second
line sets the charge current and the value on the right side of second line
sets the cell count and voltage of the battery pack. After setting the current
and voltage, press

Start/Enter

for more than 3 seconds to start the next

process.

Charge current: 0.05

–

30A, Voltage: 1

–

10 series ( LiFe to 12 series)

iCharger

and the right side of the first line ‘S:xxSER‘ is the number of cells

Start/Enter

. If not, press

Batt type/Stop

to go back to the

previous screen and adjust the setting.

Lithium FAST charging mode. The screen shows the status during the
charging process. You can stop charging at any time by pressing

Batt

type/Stop

. Press

Inc



to display each cell‘s voltage (see the balance

voltage information) and press



Dec

to display the General Status

Information.

Battery