icetro ID-0160-AN, Инструкция по установке и обслуживанию

Страница: 31 / 46

Disassembly ID-0160
Wingnut (3)
Removal and Replacement of Ice Hopper, Extruder, Auger, & Evaporator
1. Turn off the power switch and the circuit breaker, unplug the power cord from the outlet, close the valve on the
water supply line, and remove all panels except for the back.
2. Follow the previous instructions to remove the dump valve and water reservoir.
3. Remove the top and center support brackets on the front of the machine.
4. Loosen and set aside the Main PCB & FND PCB assemblies (no need to remove any wires) by removing 4 screws.
5. Remove the ice hopper cover.
6. Remove the agitator assembly and ice base plate, individually, by turning both counter-clockwise.
7. Remove the 3 wingnuts located underneath the ice hopper.
8. Lift up on the ice hopper to remove it from the evaporator assembly.
▪
Ice Hopper
Ice Base Plate
Agitator
4 PCB Screws
Top/Front
Bracket
Center/Front
Bracket
31