ICE TECH PS
13
4. INSTALLATION
4.1. Recommended placement of unit
IMPORTANT!
The ice cube maker is delivered on a small wooden pallet and is protected with a cardboard box
and packaging. Loosen the cardboard box by cutting the straps, then lift vertically.
After having removed the packaging, make sure
it and go to the distributor who sold it to you.
This operation has to be performed with the wooden base structure firmly placed on the ground.
All packaging elements (plastic bags, cartons, etc..) must not
they are a potential source of danger.
Place the machine where it is to be installed and verify, using a level control, that the machine is
in a horizontal position.
IMPORTANT!
If the space between the back of the machine
or if it is going to receive hot air from another device, we strongly advise, in case another
location is not possible, to INSTALL A WATER
IT IS IMPORTANT THAT THE WATER INLET TUBE DOES NO
AREAS IN ORDER NOT TO LOSE PRODUCTION OF ICE.
Take into consideration the previous remarks if the premises where the machine is placed are
very dusty or smoky.
We advise against installing the machines in KITCHENS, specially the air
To facilitate a easy Access to condenser and/or water pressure valve, allow sufficient space at
front of the machine. Be sure that floor is firm and even.
4.2. Water and Drainage
Water quality influences ice hardness, flavour, and quality as
Keep in mind the following points:
ICE TECH PS Technical Service Manual
placement of unit
The ice cube maker is delivered on a small wooden pallet and is protected with a cardboard box
and packaging. Loosen the cardboard box by cutting the straps, then lift vertically.
After having removed the packaging, make sure the machine is complete. If in doubt do not use
it and go to the distributor who sold it to you.
This operation has to be performed with the wooden base structure firmly placed on the ground.
All packaging elements (plastic bags, cartons, etc..) must not be left at childr
ial source of danger.
Place the machine where it is to be installed and verify, using a level control, that the machine is
If the space between the back of the machine and the wall of the room/counter is not sufficient
or if it is going to receive hot air from another device, we strongly advise, in case another
INSTALL A WATER-COOLED MACHINE.
IT IS IMPORTANT THAT THE WATER INLET TUBE DOES NOT PASS BY OR NEAR HEAT
AREAS IN ORDER NOT TO LOSE PRODUCTION OF ICE.
Take into consideration the previous remarks if the premises where the machine is placed are
We advise against installing the machines in KITCHENS, specially the air
To facilitate a easy Access to condenser and/or water pressure valve, allow sufficient space at
front of the machine. Be sure that floor is firm and even.
Water quality influences ice hardness, flavour, and quality as well as condenser life.
Keep in mind the following points:
Technical Service Manual
The ice cube maker is delivered on a small wooden pallet and is protected with a cardboard box
and packaging. Loosen the cardboard box by cutting the straps, then lift vertically.
the machine is complete. If in doubt do not use
This operation has to be performed with the wooden base structure firmly placed on the ground.
be left at children’s reach, since
Place the machine where it is to be installed and verify, using a level control, that the machine is
and the wall of the room/counter is not sufficient
or if it is going to receive hot air from another device, we strongly advise, in case another
T PASS BY OR NEAR HEAT
Take into consideration the previous remarks if the premises where the machine is placed are
We advise against installing the machines in KITCHENS, specially the air-cooled version.
To facilitate a easy Access to condenser and/or water pressure valve, allow sufficient space at
well as condenser life.
