ICETEAM 1927 COMPACTA VARIO US, Инструкция по эксплуатации

Страница: 33 / 54

Compacta VariO US
- 33 -
Compacta VariO US - 2018/05 - Rev. 01
EN
4.8 SETTING OF A FREE PROGRAM
When the machine is set to Stop on both sides, press
Compacta 4
button for 5”, and the lower line will
show the names of the free programs:
15:26:14 Mon
Free Program 1
Press Increase and Decrease buttons to select the cycle to be set up (e.g.: Free Program 1). When
Compacta 4
button is pressed, the display will read:
15:26:14 Mon
020 --> 050 V=3 F=3
The second line - from left to right - shows:
- 020 --> 050: HOT limit values for step 1 (e.g.: from 20 to 50 of HOT)
- V=3: beating speed in the selected range
- F=3: cooling power in the selected range (can be edited from 1 to 3)
At the beginning, value 50 (first intermediate set of HOT) is flashing and its value can be edited
through the Increase and Decrease keys. The value can be set to any value, from the lowest of
the range (20 in the example) to 120.
Once the correct value has been selected and confirmed with
Compacta 4
button, the beater speed
value, which can be edited from 1 to 7 using the Increase and Decrease keys, will start flashing.
15:26:14 Mon
020 --> 050 V=3 F=3
As already stated, once the correct value has been selected and confirmed with
Compacta 4
button,
the cooling power value, which can be edited from 1 to 3 using the Increase and Decrease keys,
will start flashing.
15:26:14 Mon
020 --> 050 V=3 F=3
Press
Compacta 4
button for 3” to switch to the next consistency range. The pre-set values relevant to
step 2 will be displayed and the first editable parameter will start flashing:
15:26:14 Mon
020 --> 070 V=3 F=3
Set the values of Steps 2 and 3 as described above.
Pressing
Compacta 4
button for 3” during step 3 parameter setting, the whole cycle is stored and the
display shows the message "STORED CYCLE".
4.8.1 Performing a free program
When the free program is stored, it is also enabled and then made available under Ice cream menu.
To perform a free program, press
Compacta 4
button from Stop mode, select the free program to perform
and start it by pressing
Compacta 4
button again or waiting for a few seconds.
Note: Both free and automatic cycles have a pre-cooling stage, with beating at speed 3 and
maximum cooling power.
Note: Like automatic cycles, free cycles can be disabled (the cycle is "hidden" to the user but the set
values remain stored and the cycle can be restored by means of "Setting a free program" procedure)
Note: by default, free programs are disabled and will not appear in the list of production cycles.
The program will be listed among the cycles which can be carried out only after setup.