4
SAFETY
SAVE THESE INSTRUCTIONS
Electrical Connection
Do not, under any circumstances, cut or remove the third (ground) prong from the power cord.
For personal safety, this
ICER-ETTE
TM
must be properly grounded. The power cord of this
ICER-
ETTE
TM
is equipped with a
standard IEC
3-prong grounding plug that mates with a standard 3-prong
grounding wall outlet to
minimize the possibility of electric shock hazard from the
ICER-ETTE
TM
.
115VAC plug is standard NEMA 15-5P and 230VAC plug is IEC Type F.
Have the wall outlet and
circuit
checked by a qualified electrician to make sure the outlet is properly grounded. When a
standard
2-prong wall outlet is encountered, it is your responsibility and obligation to have it
replaced with a
properly grounded 3-prong wall outlet.
The
ICER-ETTE
TM
should always be plugged into its own individual electrical outlet which has a
voltage rating that matches the rating label on the
ICER-ETTE
TM
. This provides the best
performance and also
prevents overloading boat wiring circuits which could cause a fire hazard from
overheated wires. Never unplug your
ICER-ETTE
TM
by pulling on the power cord. Always grip the
plug firmly and pull
straight out from the outlet. Repair or replace immediately all power cords that
have become frayed or otherwise damaged. Do not use a cord that shows cracks or abrasion damage
along its length or at either end. When moving the
ICER-ETTE
TM
, be careful not to damage the
power cord.
If the supply c
o
rd is damaged, it must be replaced by the manufacture, its service agent or similarly
qualified persons in order to avoid a hazard.
Extension Cord
Because of potential safety hazards under certain conditions, it is strongly recommended that you do
not use an extension cord with this
ICER-ETTE
TM
.
SAVE THESE INSTRUCTIONS SAVE THESE,
L588 1222 jlc
•
Make certain that hoses are not pinched, kinked or damaged during installation.
•
Connect to potable water supply only.
•
Check for leaks after water line is connected.
•
Although the unit has been tested and cleaned at the factory, due to long-term transit and
storage, the first batch of cubes must be discarded.
•
Remove the packing materials and clean the
ICER-ETTE
TM
before using.
•
Turn on the water supply tap before switching on the
ICER-ETTE
TM
. Never turn the water
supply
tap off when the
ICER-ETTE
TM
is working.
unless otherwise instructed in this manual.
•
Except to take ice from the unit, keep the door closed in order to reduce ice melting and to
promote proper ice formation.
•
If the
ICER-ETTE
TM
will not be used for a long time
,
the interior must be cleaned with a mild
soap and water solution.
•
Do not use solvent-based cleaning agents or abrasives on the interior. These cleaners may
transmit taste to the ice cubes, or damage or discolor the interior.
•
Cleaning and user maintenance shall not be made by children without supervision.
PN:186656620
5
