Ice iS1100L, Руководство оператора и каталог запасных частей

Страница: 26 / 63

24 ICE iS1100L
OPERATOR
TROUBLESHOOTING
Trouble Possible cause Remedy
The machine does not start when
turning the machine on.
The battery connector (44) is
disconnected.
Connect the battery connector.
The FM fuse in the holder (54) is open. Replace the FM fuse.
The battery charger cable is connected
to the electrical mains.
Disconnect the battery charger cable
from the electrical mains.
The main brush does not work. The main brush microswitch faulty. Replace the main brush microswitch.
The side brushes do not operate.
The main brush is not lowered. Lower the main brush.
The side brush microswitch faulty. Replace the side brush microswitch.
The machine operates only when
stationary, otherwise battery level
The batteries are discharged.
Charge the batteries.
If the problem persists, replace the
battery.
The battery autonomy is low.
The batteries are dead. Replace the batteries.
The battery capacity is low.
Buy batteries with higher capacity
(see the Technical Data paragraph).
SCRAPPING
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly
according to the Law in force:
- Batteries - Engine oil
- Plastic hoses and components - Electrical and electronic components (*)
(*) Refer to the nearest ICE Center especially when scrapping electrical and electronic components.
ALARMS
Active alarms are shown on the display.
Alarm #id Meaning Action
F01:Seat Empty No sit in the seat or Seat circuit open Sit in the operator seat or Check circuit
F04:Vac Mtr O.L RE-START Vac Mtr ammeter protection Verify vacuum motor working current value
F05:Main Bru Mtr O.L RE-START Main bru mtr ammeter protection Verify main bru motor working current value
F06:Side Bru Mtr O.L RE-START Side bru mtr ammeter protection Verify side bru motor working current value
F07:Propel Mtr O.L Propel Motor ammeter protection Verify Propel Motor current value
F10:Batt Low Charge batt Battery is low Charging the battery
F11:Batt Very Low Charge batt
NOW!!
Battery is very low Charging the battery
F12:Brake Wiring Error Brake circuit open Check brake wirings and circuit
F13:Release Foot Pedal
Steping the foot pedal when starting
machine
Release the foot pedal when turn on the machine
F14:Replace Brake Assy Brake circuit short Check brake wirings and circuit
F16:Control Unit Overheat! Wait Over Temp or Control Unit Fault
Verify motor working current value or Change
Control Unit
F17:Replace Control Unit Temp. Sensor failure ChangeControl Unit
F18:Replace Foot Pedal Assy Foot Pedal Sensor failure Verify pedal wirings and pedal sensor
F20:Check Main Brush Motor Main Motor error or circuit open Verify wirings and main brush motor
F21:Check Vac Mtr Vac Motor error or circuit open Verify wirings and vac motor
F24:Check Propel Motor Propel Motor error or circuit open Verify wirings and propel motor
F25:Check Side Brush Motor Side Brush Motor error or circuit open Verify wirings and side brush motors
F40:Check Proximity Sw Sw Sensor failure Change Sw Sensor
F42:Replace Control Unit Relay Contact error Change Control Unit
Emergency stop button be actived or
circuit open
Reset emergency stop button,restart the machine
or check circuit
F44:Replace Control Unit Control Unit Fault Change Control Unit
F45:Return Control Unit Control Unit Fault Change Control Unit
F46:Return Control Unit Control Unit Fault Change Control Unit
F47:Replace Control Unit Control Unit Fault Change Control Unit
F48:Return Control Unit Control Unit Fault Change Control Unit