Ice i20B, Руководство оператора и каталог запасных частей

Страница: 8 / 29

ICE i20B 8
OPERATOR MANUAL
5. Occasionally check the battery meter (see
machine components, item #2) . When
meter is in the red, stop scrubbing and
recharge the batteries.
TANK DRAINING
1. Turn the machine off.
2. With the squeegee and scrub head in their
"UP" position, transport the machine to an
approved area for draining tanks.
WARNING: When battery meter is
in the red, do not continue to operate the
machine. Battery damage may result.
6. When the solution tank runs empty, turn off
the brush switch, solution switch and raise
the scrub head. Keep the squeegee down
and continue to vacuum until all the dirty
water is picked up.
NOTE:
See
TANK DRAINING
section to learn
how to drain recovery and solution tanks.
DRAINING THE RECOVERY TANK
NOTE: Any time scrubbing is completed, or
when refilling solution tank, the recovery tank
should be drained and cleaned.
WARNING:
If the recovery tank is not
drained when the solution tank has been
refilled, foam or water may enter the float
shut-off mechanism and cause damage to
the vacuum motor.
1. While holding the drain hose (see machine
components, item #18) upward, remove the
cap and lower hose to drain.
2. Open the cover tank and rinse out the tank.
Use a rag to remove any excess dirt.
3. Clean the float shut-off screen located in the
recovery tank.
DRAINING THE SOLUTION TANK
NOTE:
Any time scrubbing is completed, the
solution tank should be drained and cleaned.
1. Pull down on the clear tube (back left of the
machine, see machine components, item
#8) to remove it from the hose barb. This
will allow the solution to flow freely into a
bucket or floor drain.
2. Rinse the solution tank with clean water after
every use. This will help prevent chemical
buildup and clogging of the solution lines.
3. Once tank is rinsed, flushed and drained,
reconnect the clear tube to the hose barb. Be
sure the tube is pushed all the way up on the
hose barb.
4. Screw off the cover of the water filter(see
machine components, item #14) to compeletly
exhaust the tank and check the filter screen,
clean it up if necessary.
5. Screw up the cover of the water filter, be sure
to install the screen and the "O" ring in the
correct position.
BATTERY CHARGING
WARNNING: Fire or explosion hazard.
Batteries may emit hydrogen gas. Keep
sparks and open flame away. Keep battery
compartment open when charging.
NOTE: Use only approved chargers with the
following specifications:
- Automatic shut off circuit.
- Deep cycle charging.
- Output current of 10-20 Amps.
- Output voltage of 24 volts.