Ice i20B, Руководство оператора и каталог запасных частей

Страница: 7 / 29

ICE i20B
7
OPERATOR MANUAL
FILLING THE SOLUTION TANK
The machine is equipped with a hose filling port
(see machine components, item #7) at the rear
of the machine, and a bucket filling port (see
machine components, item #23) located under
the recovery tank. Before accessing the bucket
filling prot make sure that the recovery tank is
empty.
WARNING: Do not put any flammable
materials into solution tank. This can
cause an explosion or a fire. Only use
recommended cleaning chemicals. Contact
your janitorial supply distributor for
recommendations on proper chemicals.
1. Go slow on inclines and slippery surfaces.
Do not operate the machine on inclines that
exceed 5% (3°).
2. Do not keep the machine in the same
position with the pad / brush spinning, keep
the machine moving to prevent damage to
the floor
.
3. If the squeegee assembly leaves streaks
on the floor, raise the squeegee off the floor
and wipe the blades down with a damp
cloth. Pre-sweep the area to prevent leaving
streaks on the floor.
4. Pour recommended defoamer into the
recovery tank if excessive foam appears.
NOTE: When filling the solution tank with a
bucket, make sure that the bucket and water is
clean.
MACHINE OPERATION
WARNING: Do not operate machine
unless you have read and understand this
manual.
1. Lower squeegee assembly to the floor by
lowering the squeegee lifting level (see
machine components, item #26).
2. Lower the scrub head to the floor by step on
the scrub head lifting pedal (see machine
components, item #9) .
3. Turn the main power key (see machine
components, item #6) to the on (I) position.
4. Check the battery level meter (see machine
components, item #2), if the red light is on,
DO NOT continue to operate the machine and
charge the batteries immediately.
5. Check the soluion flow indicator (see machine
components, item #3), adjust the solution flow
control switch to a desired flow rate.
NOTE: Solution will not begin to flow until the
control handle is pulled.
6. Pull the control handle (see machine
components, item #19) to start scrubbing by
moving the machine forward.
NOTE: 45-60 meters (150-200 ft) per minute
is the recommended scrubbing speed.
7. Turn the main power key (see machine
components, item #6) to the on (I) position.
8. To stop scrubbing, release the control
handle, raise the scrub head and the
squeegee assembly.
WHILE OPERATING MACHINE
WARNING: Fire or Explosion Hazard.
Do not pick up flammable materials or
reactive metals.
WARNING:
Foam must not enter the
float shut-off screen, or damage can occur
to the vacuum motor. Foam will not activate
the machine's float shut-off device.